Eicon Networks C21 Guida di Installazione Scaricare il pdf (Pagina 119)

DIALER Status 119

Bits per byte

Sets the number of bits used to represent a character. The

number of bits per character must be set to the same value on both ends of an

Eiconcard-to-modem connection. This parameter is used in the asynchronous

mode only, and it allows for the specification of call setup commands issued

before a connection is established with an external modem. Default value: 7.

Clock type

The type of clocking used by the modem.

Carrier signal

Indicates whether there is currently a modem carrier signal.

When there is no carrier signal, there is no connection.

Data encoding

The type of data encoding used on the connection. Both

ends must use the same data encoding.

Ring Indicator signal

The current status of the RI signal.

Data Set Ready signal

The current status of the DSR signal.

Data Terminal Ready signal

The current status of the DTR signal.

Value Description

7 - 8 Bits per Character; must be the same setting as external modem.

Value Description

Internal The Eiconcard generates an internal clock for receiving and

transmitting, and outputs this clock on the interface for use by the

DCE.

External The Eiconcard uses an external clock supplied by the DCE for

receiving and transmitting.

INT+DPLL The Eiconcard employs a DPLL which uses an internally generated

clock which is 32 (NRZI) or 16 (FM) times the data rate.

EXT+DPLL The Eiconcard employs a DPLL which uses a DCE generated clock

which is 32 (NRZI) or 16 (FM) times the data rate.

Value Description

On Carrier signal present.

Off Carrier signal not present.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 214 215

Nessun commento

Eicon Networks C21 Guida di Installazione Pagina 119