Eicon Networks C21 Guida di Installazione Scaricare il pdf (Pagina 87)

ECDIALER and ISDN 87

usually returns “OK” to acknowledge a command. Use MATCH “OK” to wait

for the “OK” string. The string must be enclosed in quotation marks. MATCH

waits the number of seconds specified in a previous TIMEOUT command. Use

IFERROR directly following MATCH to test for success or failure. This

command reads and ignores any characters before the match is found or a

timeout occurs.

OPEN_COMM

This command initializes the Eiconcard for communication

with the external modem. The initialization values for this command are

specified with the five SET_xxxx commands. Success or failure is determined

with the IFERROR command.

PAUSE

Pauses execution of the script file until any key is pressed on the

keyboard. This is useful when debugging a script.

PRINT string

Displays the specified string on the screen.

SET_DATA_BITS n

This command sets the number of data bits put into effect

by a subsequent OPEN_COMM command. Valid values for “n” are 7 or 8 data

bits. The default is 8 data bits.

This is the asynchronous data bit setting used by the Eiconcard Hayes dialer

port to communicate with an external modem.

SET_PARITY n

Selects the parity of the connection put into effect by a

subsequent OPEN_COMM command. Valid values for n are: NO_PARITY,

EVEN_PARITY, or ODD_PARITY. The default is NO_PARITY.

This is the parity setting used by the Eiconcard Hayes dialer port to

communicate with an external modem.

SET_PORT n

Specifies the Eiconcard port to use when communicating with

a modem. SET PORT takes effect when an OPEN_COMM command is

executed. Valid values for n range from 1 to 48. The default is 1.

SET_SPEED n

Sets the bits per second (bps) rate put into effect by a

subsequent OPEN_COMM command. Valid values are: 1200, 2400, 4800,

9600. The default is 2400 bps.

This is the speed setting used by the Eiconcard Hayes dialer port to

communicate with an external modem.

SET_STOP_BITS n

Selects the number of stop bits. Set n to 1 or 2 stop bits.

By default, 1 stop bit is used. This command is not taken into account by

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 214 215

Nessun commento

Eicon Networks C21 Guida di Installazione Pagina 87