Eicon Networks C21 Guida di Installazione Scaricare il pdf (Pagina 70)

ECCARD: Starting the Eiconcards 70

ECCARD DUMP

The DUMP command saves the contents of Eiconcard memory to disk for later

analysis. Running ECCARD DUMP disconnects all active connections

through the gateway and stops the Eiconcard.

If you are having trouble establishing a connection and are unable to find the

source of the problems, a DUMP can be useful. In most cases, the DUMP is

done under the advice or supervision of an Eicon Networks representative. The

DUMP file can then be analyzed, and a solution found to your problem.

If you are dumping the contents of an Eiconcard for the first time, the default

filename is DUMPx.001, where x is the number of the Eiconcard. For each

subsequent dump, the file extension is incremented by 1: DUMP1.001,

DUMP1.002, DUMP1.003, etc. If you delete all the DUMP files from the target

directory, the counter will restart at 001.

Example

ECCARD DUMP /E 2 /B TESTDUMP.DMP

Dumps Eiconcard #2 to a file called TESTDUMP.DMP.

ECCARD LIST

The ECCARD LIST command displays information on each Eiconcard

protocol executable as if it were being started, but does not actually run the

executable. This is useful to determine if the right software will be started based

on the configuration selected.

Example

ECCARD LIST

ECCARD STATUS

The ECCARD STATUS command provides a list of Eiconcards and their ports,

detailing hardware configuration information based on the values entered in

the Eiconcard configuration file.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 214 215

Nessun commento

Eicon Networks C21 Guida di Installazione Pagina 70